| | | Low Initial Cost and Quick (ROI) Return on Investment – The Pipe Bully differs from a welding positioner in the fact that it does not tilt. The table is fixed at 90 degrees and designed to be used with an adjustable outboard roller support. By eliminating the tilting components the price can be reduced by approximately 50% over a comparable sized welding positioner. |  | | Increase Welding Productivity – The Pipe Bully rotates the pipe allowing all of the pipe welding to be performed in the flat position. Pipe welding in the flat position not only increases the speed of pipe welding but also lowers the difficultly and increases the quality of the pipe weld reducing rework and scrapped pipe welding work. |  | | Rugged and Low Maintenance – The Pipe Bully’s heavy duty construction results in years of trouble free service. Featuring a heavy duty all worm gear rotation drive, there are no belts, chains or sprockets to adjust or maintain. All of the bearings and gearing is fully sealed from contamination and lubricated for long life and safety. The DC control and foot switch are housed in a Nema 4X watertight dustproof enclosures. Heavy duty fixture welded frame with baked on powder coat finish and 600 volt power input cable and motor cables for extra abrasion resistance. All lead to many years of trouble free service. |  | |
Made in the USA – The Pipe Bully is made in the USA using standardized American made components such as motors, controls and gearing which can be easily purchased through any local supplier.
| | | | Low Voltage Input Power – The Pipe Bully uses AC 120 volt 60 Hz single phase input power allowing it to be located anywhere in the shop where there is a 120 volt outlet. |
|
